top of page

Destek Grubu

Herkese Açık·20 üye
Swarnali Hena
Swarnali Hena

Flysky Fs Ct6b Driver


Flysky Fs Ct6b Driver




The Flysky Fs Ct6b is a 6-channel radio transmitter and receiver system that can be used to control various RC models, such as planes, helicopters, cars, and boats. It operates on the 2.4 GHz frequency band and has a range of up to 500 meters. The transmitter has a LCD screen that displays the settings and parameters, and can be connected to a computer via a USB cable for programming and configuration. The receiver has a built-in failsafe function that can be set to return the model to a safe position in case of signal loss.


DOWNLOAD: https://quenewssemu.blogspot.com/?om=2w3DJq


To use the Flysky Fs Ct6b, you need to install the driver for the transmitter USB cable on your computer. There are three different drivers available, depending on the type of cable you have. You can download them from [this website]. After installing the driver, you need to download the programming software for the transmitter, called T6 Configuration. You can download it from [this website]. You need to unzip the file and run the T6 Configuration.application file. Then, you can connect the transmitter to your computer and launch the software. You will see a window like this:



The software allows you to adjust various settings of the transmitter, such as channel mapping, end points, trim, dual rates, exponential, sub trim, reverse, and mixing. You can also save and load different profiles for different models. To program the transmitter, you need to follow these steps:



  • Turn on the transmitter and connect it to your computer via the USB cable.



  • Launch the T6 Configuration software and click on "Read" to read the current settings from the transmitter.



  • Modify the settings according to your preferences and needs. You can use the sliders, buttons, and checkboxes to change the values. You can also click on "Help" to get more information about each setting.



  • Click on "Write" to save the new settings to the transmitter.



  • Disconnect the transmitter from your computer and turn it off.




Now, you are ready to use your Flysky Fs Ct6b with your RC model. You need to bind the transmitter and receiver before using them for the first time. To do this, you need to follow these steps:



  • Turn on the transmitter and set it to PPM mode.



  • Plug the bind plug into the BAT port of the receiver.



  • Connect a battery or power supply to any other port of the receiver. The LED on the receiver will start flashing rapidly.



  • Press and hold the bind button on the back of the transmitter for a few seconds. The LED on the receiver will stop flashing and become solid.



  • Remove the bind plug from the receiver and disconnect the battery or power supply.



  • Turn off the transmitter and turn it on again. The LED on the receiver will blink once and then become solid again.




Congratulations! You have successfully bound your Flysky Fs Ct6b transmitter and receiver. You can now enjoy flying or driving your RC model with this system. For more information about this product, you can visit [the official website] of FlyskyRC.


Hakkında

Gruba hoş geldiniz! Diğer üyelerle bağlantı kurabilir, günce...

Üye

  • Remini Three
    Remini Three
  • Landon Richardson
    Landon Richardson
  • Rostislav Stepanov
    Rostislav Stepanov
  • info.tvactivatecode
  • Klim Gromov
    Klim Gromov
bottom of page